Fire Engineering Training Community

Where firefighters come to talk training

I would think it’s safe to say that practically every truck company in the US carries a K-12, whether Partner, Stihl, or Husqvarna. Departments without dedicated trucks often carry these versatile saws on their engines. Obviously we also find them on squads and heavy rescue companies.

They are a great tool to have and if you’re lucky you have at least two. There’s a lot that can be discussed about these saws, not only blade position but the type of blade to run.

With regards to blade position, most saws can be mounted in board ( blade in front of engine) or out board (blade to side of saw). There is a reason for each.

In board is how you typically find these cut off saws. When being used for concrete or for ventilation this is the ideal position to have the blade. It provides the most stability and minimizes the gyroscopic effect when bringing the saw to full RPM.

If your saw is to be used for forcible entry, out board is the position of choice and best suited for the task. With an outboard blade, you will have better access to cutting carriage bolts on drop bars, shaving carriage bolt heads on drop bars mounted with steel plates between the bolt head and skin of the door. It will also allow better access to cut hinges, cut mortise deadbolts if through the lock has failed or is not an option, and allow the blade to get close enough to the ground to go underneath the door to cut pins at the bottom of the door.

Below you will find photos of some K970s in both positions. Look carefully to see angle of approach for both positions when taking hinges or floor pins. Also notice how close you can get to the carriage bolt heads to shave them off next to the steel plate.

If you only have one saw, you must decide which configuration best suits your needs. Do you vent more or use it for forcible entry??  An outboard K-12 can be used for venting so keep that in mind.

Views: 9130

Comment

You need to be a member of Fire Engineering Training Community to add comments!

Join Fire Engineering Training Community

Policy Page

PLEASE NOTE

The login above DOES NOT provide access to Fire Engineering magazine archives. Please go here for our archives.

CONTRIBUTORS NOTE

Our contributors' posts are not vetted by the Fire Engineering technical board, and reflect the views and opinions of the individual authors. Anyone is welcome to participate.

For vetted content, please go to www.fireengineering.com/issues.

We are excited to have you participate in our discussions and interactive forums. Before you begin posting, please take a moment to read our community policy page.  

Be Alert for Spam
We actively monitor the community for spam, however some does slip through. Please use common sense and caution when clicking links. If you suspect you've been hit by spam, e-mail peter.prochilo@clarionevents.com.

FE Podcasts


Check out the most recent episode and schedule of
UPCOMING PODCASTS

Groups

© 2024   Created by fireeng.   Powered by

Badges  |  Report an Issue  |  Terms of Service