Fire Engineering Training Community

Where firefighters come to talk training

Isaac Frazier's Blog – May 2014 Archive (6)

Extrication Quick Tip #6 (Stabilization with less)

What happens when you arrive on scene of an entrapment and have no struts or specialized equipment? Look at your apparatus and prepare for various stabilization scenarios. What do you have to stabilize until backup arrives? The picture shown, is a quick and easy Engine Co. stabilization. Is it better than a strut system? No. But it does work well with a couple wedges for a quick under equipped company. Backboard, come-a-long and wedges is a quick option. Just remember, not every department…


Added by Isaac Frazier on May 27, 2014 at 9:21am — No Comments

Extrication Quick Tip #5 (TOOL STAGING)

Do you currently stage your equipment/tools on extrications? If not, it is a great method to reduce extrication times. Far too often, we see rescuers going back to the apparatus to get additional equipment throughout the call. My driver is the tool runner. After we start operations, he will continue to bring the tools, light the scene, and fill in where needed. Stage the tools you may need for the rescue at hand, it will greatly increase your overall scene time.…


Added by Isaac Frazier on May 19, 2014 at 8:54am — No Comments

Doing our part through donation.

It's all about doing our part. $1,200 dollars from this weekends class donated to the National Fallen Firefighters Foundation. RFB

Added by Isaac Frazier on May 12, 2014 at 9:00am — 1 Comment

Extrication "Quick Tip" 4 (PEDAL PULL)

On many entrapments, pedal-foot entanglements can be a common problem. This method is an easy alternative to cutting. Prior to removing the front door, loop the pedal to be displaced with webbing. Then wrap the excess webbing on the door frame (with the door almost shut). Hold the webbing wrap and open the door to displace the pedal towards you. This method can be also used on the passenger side door for displacement in that direction.…


Added by Isaac Frazier on May 12, 2014 at 7:20am — No Comments

Extrication "Quick Tip" 3 (PIE CUT)

Not all responders are blessed with the newest equipment. If a high strength post is too much for your cutter, attempt a pie cut as shown. Many times this will allow you to "cut around" the stronger portions of the post.   

Added by Isaac Frazier on May 5, 2014 at 7:42am — 1 Comment

Developing an Extrication Sequence

The time was 2:35am as the crew of Squad 4 was being diverted off a previous call. Dispatch relayed the information, “Squad 4 respond to a MVC involving three vehicles, with a confirmed entrapment.” This stretch of Interstate 95, has been a consistent location for bad entrapment crashes. As the officer on Sq-4, it was the moment of truth. Climbing off the rig, among a maze of damaged vehicles, I remained focused on the task at hand. Each member of the crew had a task.  After grabbing the…


Added by Isaac Frazier on May 1, 2014 at 8:11am — No Comments

Policy Page


Our contributors' posts are not vetted by the Fire Engineering technical board, and reflect the views and opinions of the individual authors. Anyone is welcome to participate.

For vetted content, please go to

Fire Engineering Editor in Chief Bobby Halton
We are excited to have you participate in our discussions and interactive forums. Before you begin posting, please take a moment to read our policy page. -- Bobby Halton

Be Alert for Spam
We actively monitor the community for spam, however some does slip through. Please use common sense and caution when clicking links. If you suspect you've been hit by spam, e-mail

FE Podcasts

Check out the most recent episode and schedule of

© 2021   Created by fireeng.   Powered by

Badges  |  Report an Issue  |  Terms of Service