Fire Engineering Training Community

Where firefighters come to talk training

I wanted to know if any depts are using a 2 1/2" to two 2 1/2" outlet gated wyes for the hookups (to the standpipe outlet) to allow for one person to control the standpipe discharge for 1st and 2nd line and cut down on lengths needed and people for the second line usually hooked up two floors below? For 2 1/2" lines of course. Thanks

Ian

Views: 300

Reply to This

Replies to This Discussion

OKla. City uses 1- 21/2" line per standpipe outlet. Lots of discussion about these things in the High-Rise Group. Come join!
my dept uses a 10- 15 21/2 pony to a gated wye off the stand pipe. a high-rise bag is carried with pipe wrench, chocks, a short piece of rope, a screwdriver, and a pair of pliers.
Ian

We connect to the standpipe with a 10' section of 2.5" hose conected to a gated wye, from there we conect (2) 1.75" attack lines.

For condo nozzles we are using TFT mid matic 50 psi, this gives us 180 gpm and the psi can be controled at the nozzle without messing up the stream, what are you guys using for nozzles?

Dan
Ian
When it comes to Standpipes, the problems usually are the outlet themselves. This would be akin to the folks who like to use 1 3/4" hose attached to a gated wye. If your backup line comes off the same outlet, what happens when there is a failure of the outlet? Maybe there is a factory pre-set PRD on the outlet? Sometimes you cannot tell the difference till it is too late. Now both your primary and backup lines are out of service, and the members are scrambling for an area of refuge! To bring a backup line from one floor below usually means one additional length. There should be mandatory inline gauges on each outlet for safety, (these should be in your kit.) Keep smoothbore 1 1/8" tips on the hose rollups, and here is a hint.....run them at 40 psi nozzle pressure. You will be suprised at the difference in nozzle reaction, and the gallonage is still there.
Keep the gated wyes on the pumpers. Weather it is small or big lines. You have a lot going against you in a Standpipe Op. Don't add to the mix!
I agree with the back up line comment totally. Great points!

Reply to Discussion

RSS

Policy Page

PLEASE NOTE

The login above DOES NOT provide access to Fire Engineering magazine archives. Please go here for our archives.

CONTRIBUTORS NOTE

Our contributors' posts are not vetted by the Fire Engineering technical board, and reflect the views and opinions of the individual authors. Anyone is welcome to participate.

For vetted content, please go to www.fireengineering.com/issues.

We are excited to have you participate in our discussions and interactive forums. Before you begin posting, please take a moment to read our community policy page.  

Be Alert for Spam
We actively monitor the community for spam, however some does slip through. Please use common sense and caution when clicking links. If you suspect you've been hit by spam, e-mail peter.prochilo@clarionevents.com.

FE Podcasts


Check out the most recent episode and schedule of
UPCOMING PODCASTS

Groups

© 2024   Created by fireeng.   Powered by

Badges  |  Report an Issue  |  Terms of Service