Fire Engineering Training Community

Where firefighters come to talk training

We at the Wake Forest FD are planning on painting the tips of our ladders according to NFPA. We are looking to paint the tips with a red reflective paint for higher visibilty at night. Has anyone used or can anyone give me advise on taking on this project. I have not had much success on finding red reflective paint.

What does your department do???

Views: 3205

Replies to This Discussion

At my department we recently painted the tips of our ground ladders. We used high visibility orange paint to paint the tips and the balance points, then a strip of reflective tape around the beams at the beginning and end of the balance point.
That is a great idea. I am going to try and implement that in my department. Good advice. Thanks.
eric
-I am curious as to which NFPA directive is recommending painting the tips of ground ladders?
I believe it is 1932, something like 6.2 off the top of my head. States something like 18" from the tip.
Michael, It's not a directive but we just want to improve the visibilty of the tips of ground ladders. NFPA states that only a certain portion of the tip can be painted if you paint them.

Michael Bricault said:
-I am curious as to which NFPA directive is recommending painting the tips of ground ladders?
-I am not familiar with many departments that paint ground ladders, especially if they are using aluminum ladders. Generally speaking it is usually wooden ground ladders that are painted and that is, in fact, what the NFPA standard was referencing.
-Moreover, painting ladders is much like painting a hand tool; it covers up and potentially hides any imperfections or problems/defects that have developed with the ladder.
-If you are truly seeking to improve the visibility of the top end of the ladder I would suggest using one inch reflective tape placed on the back side of the beams, nothing more. Painting aluminum ladders is inappropriate.
Good day...To add some Valuable incite I received many years ago..How do ONE insure that the DAWGS, are locked and loaded when we raise our ladders into place..A Wily Old Truck Veteran told me to place REFLECTIVE TAPE on the plates of the inside of the DAWG Covers.. Using your Flashlight in that Dark Alley in the Rear.. You can quickly spot those DAWGS and make sure that they are in place and locked..
We dont paint the tips however have looked at putting some type of relection tape on them. More so for our extions that would rise above the roof.

As for the middle point thats a great idea as we use our ladders as staging for our vent and RIT ops we carry all the equipment on them to the are of use.

RSS

Policy Page

PLEASE NOTE

The login above DOES NOT provide access to Fire Engineering magazine archives. Please go here for our archives.

CONTRIBUTORS NOTE

Our contributors' posts are not vetted by the Fire Engineering technical board, and reflect the views and opinions of the individual authors. Anyone is welcome to participate.

For vetted content, please go to www.fireengineering.com/issues.

We are excited to have you participate in our discussions and interactive forums. Before you begin posting, please take a moment to read our community policy page.  

Be Alert for Spam
We actively monitor the community for spam, however some does slip through. Please use common sense and caution when clicking links. If you suspect you've been hit by spam, e-mail peter.prochilo@clarionevents.com.

FE Podcasts


Check out the most recent episode and schedule of
UPCOMING PODCASTS

Groups

© 2024   Created by fireeng.   Powered by

Badges  |  Report an Issue  |  Terms of Service