Fire Engineering Training Community

Where firefighters come to talk training

This photo shows a way to make an SCBA face piece for your RIT bag/kit glove friendly. You can use a garden hose or any kind of rubber tubing or hose that would be easy to grab with a gloved hand. We used a small bungee cord and ran it through the bonnet and attached both ends to the hose. This allows for easy feeling and grabbing the back of the mask with gloved hands.

We also attached large key rings to the pull tabs for the face piece bonnet to pull it tight. These rings can be any size you want, but make sure they are easily accessed and grabbed with glove hands.

These two methods have worked very well for us and during training evolutions has stood up to the pulling and tugging.

Let us know if you have other methods that work well for your department.

Thanks and keep training hard.

Jason

Views: 1065

Comment

You need to be a member of Fire Engineering Training Community to add comments!

Join Fire Engineering Training Community

Policy Page

CONTRIBUTORS NOTE

Our contributors' posts are not vetted by the Fire Engineering technical board, and reflect the views and opinions of the individual authors. Anyone is welcome to participate.

For vetted content, please go to www.fireengineering.com/archives.

Fire Engineering Editor in Chief Bobby Halton
We are excited to have you participate in our discussions and interactive forums. Before you begin posting, please take a moment to read our policy page HERE. -- Bobby Halton

Be Alert for Spam
We actively monitor the community for spam, however some does slip through. Please use common sense and caution when clicking links. If you suspect you've been hit by spam, e-mail peter.prochilo@clarionevents.com.

FE Podcasts

Friday

Talking Trucks & Equipment

with

Chris Mc Loone

CALL IN AND JOIN THE SHOW

1-877-497-3973 (Toll Free)
or 1-760-454-8852

Check out the schedule of
UPCOMING PODCASTS

© 2019   Created by fireeng.   Powered by

Badges  |  Report an Issue  |  Terms of Service