Fire Engineering Training Community

Where firefighters come to talk training

We recently had a fire in an apartment complex. The apartments all have exterior entrances independent of each other. They are two stories in height and the landings from the upper floor units are unprotected treated lumber.

These were built prior to my current position and I don’t remember what year they were built, but I am guessing that they are about 12 years old. The fire started in a plastic planter that was next to the door and had what the tenant called “very old” potting soil in it. The tenant used the planter as a receptacle for her cigarettes.

Plastic Planter
As the fire grew, it spread to the vinyl siding and got into the soffit and on into the attic. Luckily the tenant happened to wake up and noticed a glow on the porch; no smoke detectors were activated and the unit next door was vacant.

All occupants escaped with no injuries and fire crews quickly arrived and made a good find and stop.

When they started doing overhaul they noticed something a little different about the fire barrier between the two units.

As you look at the picture below, you will notice in the upper right hand side of the photo the charred truss chase that did not extend to the left due to the draft stopping.

Draft Stopping
However, this could have been worse because this should have been a continuous fire barrier between the two units. In addition the draft stopping should be protecting both sides of the truss shown.

The problem that the builder ran into was that the truss did not line up with the separation wall and the code official at the time either missed it or let it slide.

It was a good example of how these measures work. It was also a good opportunity to show the building manager how it worked and why it is important to do these things right.

If you get a chance to look at some of these buildings as they are going up, do so and look for these types of building components and fire stopping. Oh, the ceiling did have the proper rating with two sheets of drywall.

Fire Stop the Breach
Also, that wire is a breach or penetration in the fire barrier/draft stop and should be fire stopped with rated, UL listed caulk.

Stay safe out there and be careful.

Views: 315

Reply to This

Replies to This Discussion

Thanks for posting the detailed pictures of another problem that you won't see unless you get out and look at all phases of construction process. A side not is that the cigarette potting soil incident happened also in Alaska this summer at another brothers department down in Soldotna! Lucky save, a motorcyclist drove by and saw smoke and reported it before the fire got inside! Cigarette, potting soil don't mix

Reply to Discussion

RSS

Policy Page

PLEASE NOTE

The login above DOES NOT provide access to Fire Engineering magazine archives. Please go here for our archives.

CONTRIBUTORS NOTE

Our contributors' posts are not vetted by the Fire Engineering technical board, and reflect the views and opinions of the individual authors. Anyone is welcome to participate.

For vetted content, please go to www.fireengineering.com/issues.

We are excited to have you participate in our discussions and interactive forums. Before you begin posting, please take a moment to read our community policy page.  

Be Alert for Spam
We actively monitor the community for spam, however some does slip through. Please use common sense and caution when clicking links. If you suspect you've been hit by spam, e-mail peter.prochilo@clarionevents.com.

FE Podcasts


Check out the most recent episode and schedule of
UPCOMING PODCASTS

© 2024   Created by fireeng.   Powered by

Badges  |  Report an Issue  |  Terms of Service